Supervisor Setup • Super II 31
SETUPS
MORE
SUPER
SETUP
abc reset
tare
menu remote
DATBASE
SETUP
MORE
Soft Key:
DATBASE SETUP
Setting up the Database Format, Printing/Transferring the Database
Information, and Setting the Database Security
The controller has memory for a database which has a number of configurations. The database can contain
two different types of records: database records and transactions. Database records contain stocking
information and can be recalled using the PART ID (IDØ). Transactions are stored and accessed sequentially
and each contains information about a single event or action performed on a single part. The database can
hold up to 750 records in any combination of database records and/or transactions. See TRANSAC SETUP
for details about Transaction log records and setups.
Database records and transactions are made up of fields of information. The records are comprised of the
following fields:
DATABASE:
PART ID (IDØ): (up to 23 characters)
DESC (ID4): (up to 16 characters)
LOT #(ID3): (up to 16 characters)
APW
Tare:
Count:
Low:
Target:
High:
The PART ID (IDØ) is used to index database records. When entering records into the database, the PART ID
(IDØ) must be non-empty and unique. The database is configurable to a user’s needs. The five database
setups and the disabling option are:
1. Part ID, APW, and Tare 5. Full Database (All fields available)
2. Part ID, Lot#, and APW 6. Database off
3. Part ID, APW, and Count
4. Part ID, Low, Target, High (Setpoints)
Note: The factory default is to have the database turned off.
To access the DATBASE SETUP menu, either follow the menu tree or press the soft keys in the order listed
below:
To Next Page
Loading...
Need help?
General
