Supervisor Setup • Super II 46
GO BACK
Select the base to switch to.
1. Base 1 5. Base 5
2. Base 2 6. Base 6
3. Base 3 7. Base 7
4. Base 4 8. Base 8
Macro Step ID
If the ID step is selected when programming a macro, the following menu is displayed:
Using the numeric keypad, select the field to prompt for ID entry.
Macro Step PRINT
If the PRINT step is selected when programming a macro, the following menu is displayed:
Using the numeric keypad, select the desired Print Register for printing.
Macro Step BASE
If the BASE step is selected when programming a macro, the following menu is displayed:
Using the numeric keypad, select the Base # to switch to.
Macro Step UNITS
If the UNITS step is selected when programming a macro, the following menu is displayed.
Using the numeric keypad, select the desired unit of measure.
1. Grams 5. Troy Oz
2. Ounces 6. Carats
3. Pounds 7. Kilograms
4. DWT
GO BACK
Select Units to switch to:
IDØ: PART ID ID4: DESC ID8:
ID1: OPRTR ID5: VENDOR ID9:
ID2: ORDER # ID6: REV #
ID3: LOT # ID7:
GO BACK
Select ID Field:
0. Print 0 4. Print 4 8. Print 8
1. Print 1 5. Print 5 9 . Print 9
2. Print 2 6. Print 6 –. Prt Int
3. Print 3 7. Print 7
GO BACK
Select the print setup to use:
To Next Page
Loading...
Need help?
General
