Technical Setup • Super II 76
Select backlight battery power
management value to set:
Battery brightness limit: 6
Shut-off delay time: 1.0 min.
On with BI port or Dig. input: NO
BAT LIM DELAY ON INPT GO BACK
Select backlight battery power
management value to set:
Battery brightness limit: 6
Shut-off delay time: 1.0 min.
On with BI port or Dig. input: NO
BAT LIM DELAY ON INPT GO BACK
Press the DELAY key:
The following screen appears:
Using the numeric keypad, press the desired power saving delay followed by the ENTER soft key.
When performing automated scale functions, such as computer communications through the BI port or
control by process equipment through the digital inputs, the back light will remain off. This behavior can
be changed using the ON INPT function.
Press the ON INPT soft key:
The following screen appears:
The supervisor can select automatic reactivation of the backlight if input is received on the Bi-Directional
Serial Port or one of the Digital Input lines. The default is NO.
Enter backlight shut-off delay after
last input (minutes):
Shut-off delay time: 1.0 min.
ENTER DISABLE GO BACK
Select whether backlight turns on
with input on BI port or Digital Inputs:
On with BI port or Dig. input: NO
YES NO GO BACK
To Next Page
Loading...
Need help?
General
