Settop M1-15 - Configuring the receiver

13
Configuring the receiver
IMPORTANT  : Check the Serial Number before starting to connect. Older Serial Numbers (up to
M10000300), please contact to support@settopsurvey.com
Default settings
The Settop M1 receiver comes with a default configuration to start a job easily.
The configuration of SETTOP M1 default state is:
● Main user
○ Username: admin *
○ Password: No password defined
● Station not connected
● Wi-Fi configured in ACCESS POINT
○ IP Address: 192.168.2.2
● IP Ethernet Adapter: 192.168.11.98
○ Subnet MASK: 255.255.255.0
○ Gateway: 192.168.11.1
● Bluetooth without any link
● Telephone not configured
● System:
○ Autopower: on
○ Bridge: Power Limit 15V
○ Language: English
SETTOPSURVEY, S.L. Bofarull 14, 08027 Barcelona (Spain) Phone: (+34) 93 340 05 73 Fax: (+34) 93 351 95 18 www.settopsurvey.com info@settopsurvey.com