SETTOPSURVEY, S.L. Bofarull 14, 08027 Barcelona (Spain) Phone: (+34) 93 340 05 73 Fax: (+34) 93 351 95 18 www.settopsurvey.com info@settopsurvey.com
47
Simple Base Mode
For the simple base configuration the following accessories are necessary:
•
External GPS Antenna
•
Antenna Cable
•
Tribrach
•
Extension
•
Tripod
•
Settop integrated battery or external battery
You can use the internal communication modules (either the modem or telephony radio module) to transmit
the signal to the other rover receivers.
After installing the base in the desired location, you proceed to configure it through the computer or mobile
device with Wi-Fi. You can also connect to another controller (via Bluetooth), but in this case it would be an
external control software.
Once in the GPS section and the GPSBase mode, enter the base name and enter the coordinates.
Geodetic (GG.gggggg) or UTM (Easting, Northing, Height, Zone) coordinates can be entered. If you don't
To Next Page
Loading...
