SEVERIN KV 8090 - 6.5 Cleaning the surface; 7 Troubleshooting; 7.1 Remedying problems yourself

16
10. Wait until LED ashes and button as well as the LED are lit.
11. Empty the container under the outlet.
12. Place container under the outlet again.
13. Remove the water tank, rinse and rell to MAX mark with cold tap water.
14. Re-insert the water tank.
 The LED
stops ashing. The appliance completes descaling
and then automatically switches off.
15. Empty the container under the outlet.
6.5 Cleaning the surface
Clean the surface of the appliance with the provided cloth or another soft,
lint-free cloth.
7 Troubleshooting
7.1 Remedying problems yourself
WARNING!
Risk of injury! The appliance does not contain any
parts that you can repair yourself.
– Never attempt to operate a defective appliance.
– Never attempt to repair the appliance by your-
self. If your appliance is defective, contact our
customer service department (see “Customer
service” on page 20).
Before contacting our customer service, check with the aid of the following
table whether you can remedy the problem by yourself.
Problem Cause Remedy
LED
ashes
Water tank not
inserted.
Insert water tank properly, ►“Pre-
paring the appliance” on page 9.
Only small
amount of
water in water
tank.
Add water to the water tank, ►“Pre-
paring the appliance” on page 9.
LED
ashes.
Only small
amount of
beans in bean
container.
Add coffee beans to bean container,
►“Preparing the appliance” on
page 9.
Coffee chute is
soiled.
Clean the coffee chute, ►“Cleaning
the coffee chute” on page 15.