10
Operating MOVITOOLS
®
MotionStudio Via Ethernet
Communication via Ethernet
124
Manual – Fieldbus Interface DFE33B EtherNet/IP and Modbus/TCP
10.5.5 Communication parameters for SMLP
The following table describes the communication parameters for SMLP:
Communication parameter Description Tip
Timeout Waiting time in [ms] that the client
waits for a reply from the server
after it has made a request.
• Default setting: 1000 ms
• Increase the value as
required if a delay in commu-
nication is causing malfunc-
tions.
Broadcast IP address IP address of the local network
segment within which the unit
scan is carried out.
In the default setting, the unit
scan retrieves units that are in
the local network segment only.
SMLP server IP address IP addresses of the SMLP server
or of other units that are to be
included in the unit scan but are
outside the local network
segment.
• Enter the IP address of units
that are to be included in the
unit scan but are outside
the local network segment.
Excluded IP address IP addresses of units that are not
to be included in the unit scan.
Enter the IP address of units that
are not to be included in the unit
scan. These may be units that
are not ready for communication
(for example because they have
not yet been started up).
To Next Page
Loading...
Need help?
General
