5
26
Manual – Fieldbus Interface INTERBUS UFI11A
INTERBUS Interface
Testing the PCP
connection
You can use the MONITOR mode of the CMD Tool to test the PCP connection to the
UFI. The following illustrations demonstrate the PCP test. You are basically establishing
a PCP connection with this method and read the parameter list (object directory) stored
in the device. Change the CMD Tool to the "Monitoring" operating state.
Click on the UFI to which you would like to establish a PCP connection. Open the con-
text menu with the right mouse button and select the menu item "Device Parameteriza-
tion".
05658AXX
Fig. 16: Change the CMD Tool to the "MONITO-
RING“ operating state
Fig. 17: Testing the PCP device parameterization
To Next Page
Loading...
