sewerin UT 9000 - Language; Units; Backlight; Shutdown Timer

15
2 UT 9000 R receiver
2.5.2 Settings menu item
The Settings menu item can be used to modify the following
settings:
● Language
● Units
● Backlight
● Shutdown Timer (shutdown time)
● Communications
2.5.2.1 Language
The Language menu item is used to change the language used
on the display.
2.5.2.2 Units
The Units menu item is used to modify the units of measurement
for the distance (depth) and offset depth.
2.5.2.3 Backlight
The Backlight menu item is used to switch the display backlight
on and off.
If the backlight is enabled (Autom./automatic), the display is lit
up in the case of low levels of light. The sensor for this automatic
control can be found on the control panel.
2.5.2.4 Shutdown Timer
The Shutdown Timer menu item is used to set the time after
which the device should be shut down if not in use.
If Always On is selected, the device never shuts down auto -
matically.