58
5 Active location: lines
5.4 Direction recognition
Lines may be incorrectly located if there are additional lines run-
ning close to the one to be located. The reason for this is that
neighbouring lines may also be energised unintentionally.
The direction recognition function can be used to avoid locating
incorrect lines.
● Thecurrentowsawayfromthegeneratoronthelinetobe
located, i.e. the line being energised.
● Thecurrentowstowardsthegeneratoronalinetowhichthe
current "jumps".
The direction of the current is shown on the receiver by an arrow
on the compass needles when direction recognition is enabled.
To Next Page
