33
3 UT 9005 TX / UT 9012 TX generator
3.5.3.3 Step-voltage probe
Note:
The Fault Mode menu item is only available when a set of cables
is connected to the generator. The set of cables must be connect-
ed before opening the menu.
The Fault Mode menu item is used to enable or disable a
step-voltage probe.
Step-voltage probes are used to measure cable faults. FF (Fault
Finder) will appear on the display instead of the frequency when
a step-voltage probe is enabled.
The step-voltage probe can be purchased additionally as an ac-
cessory.
3.5.4 System info menu item
The System Info menu item displays information about the de-
vice. This information may be spread across several pages.
● Press the frequency down key to display all the information.
To Next Page
