39
4 Using the UT 9000 system
4 Using the UT 9000 system
4.1 Device pairing
For active location, a receiver needs to be assigned to a gen-
erator so that the two form a device pair. To do so, the receiver
and generator are linked. The device number is the means of
identication.
Existing device pairings can be removed and the devices can
then be paired once again or different devices can be paired.
4.1.1 Pairing the generator and the receiver
During the pairing process, a generator is assigned to a receiver.
Only paired devices can communicate via radio.
Note:
the connection between the receiver and the generator can only
be established from the receiver.
1. On the generator:
− In the menu, select:
Settings > Communications > Link RX.
2. On the receiver:
a) In the menu, select:
Settings > Communications > Link TX.
b) Wait until the initialisation process is complete.
c)
Press the next key. The search for suitable devices begins.
A message appears with how many suitable devices have
been found in the area. The compatible devices are then
shown alongside their device numbers.
d) Select the desired device.
e) Press the next key. The pairing is established.
Once the receiver and generator have been paired suc-
cessfully, a message appears.
To Next Page
