38
3 UT 9005 TX / UT 9012 TX generator
2. Connect the rechargeable battery to a suitable power source
using the AC/DC adapter.
The battery will be charged. The LED on the AC/DC adapter
will display the current charging status:
LED State of charge
red battery charging
green battery fully charged (charging process completed)
Note:
The LED will still be green when the power supply
is connected to the mains, even if the rechargea-
ble battery is not connected to the charging unit.
3. Once the battery is fully charged, remove it from the power
supply.
4. Replace the battery compartment cover into the battery com-
partment. Close the battery compartment.
To Next Page
