sewerin UT 9000 - Frequencies Menu Item; Settings Menu Item; Backlight; Output

28
3 UT 9005 TX / UT 9012 TX generator
3.5.1 Frequencies menu item
The frequencies menu item is used to enable or disable the pre-
set frequencies. Symbols indicate which individual frequencies
are suitable for the different operating modes.
An explanation of these symbols can be found in section 9.2.1
on page 74.
For more detailed information on which frequencies to select,
please refer to section 4.2 on page 41.
3.5.2 Settings menu item
The settings menu item can be used to modify the following
settings:
● Backlight
● Output
● Meter
● Communications
3.5.2.1 Backlight
The Backlight menu item is used to switch the display backlight
on and off.
If the backlight is enabled (ON), an additional menu item appears:
Timer. This menu item can be used to set the time after which the
backlight is automatically switched off if the device is temporarily
not in use. Default: 5 seconds.
3.5.2.2 Output
Note:
The Output menu item is only available when a set of cables is
connected to the generator. The set of cables must be connected
before opening the menu.