sewerin UT 9000 - Page 6

II
Contents Page
3.5.2.2 Output ...............................................................................28
3.5.2.3 Meter .................................................................................30
3.5.2.4 Communications ...............................................................30
3.5.3 Options menu item ...............................................................31
3.5.3.1 Language ..........................................................................31
3.5.3.2 Defaults .............................................................................32
3.5.3.3 Step-voltage probe ............................................................ 33
3.5.4 System info menu item .........................................................33
3.6 Power supply ...........................................................................34
3.6.1 Changing the batteries .........................................................35
3.6.2 Lithium-ion rechargeable battery ..........................................36
3.6.2.1 Safety information regarding the lithium-ion rechargeable
battery ...............................................................................36
3.6.2.2 Storage of the rechargeable battery..................................36
3.6.2.3 Charging the battery..........................................................37
4 Using the UT 9000 system ....................................................39
4.1 Device pairing .........................................................................39
4.1.1 Pairing the generator and the receiver .................................39
4.1.2 Disconnecting the generator and the receiver .....................40
4.2 Frequency selection ................................................................40
4.2.1 Enabling a frequency ...........................................................42
4.2.2 Selecting the frequencies .....................................................42
4.3 Gain control on the receiver ....................................................43
4.4 Depth measurement ................................................................44
4.4.1 Determining the depth automatically ....................................44
4.4.2 Determining the depth manually ..........................................45
4.4.3 Determining the offset depth ................................................45
4.5 UT 9000 software .................................................................... 47
5 Active location: lines ............................................................49
5.1 Determining the ambient noise ...............................................49
5.2 Energising a line ......................................................................51
5.2.1 Galvanic energising ..............................................................51
5.2.1.1 Parallel connection ............................................................ 52
5.2.1.2 Points to note when changing the set of cables ................ 54
5.2.2 Inductive energising .............................................................55
5.2.2.1 Energising with a cable clamp...........................................55
5.3 Locating a line .........................................................................56
5.4 Direction recognition ...............................................................58