Sewha SI 480E - Page 23

23
SI 480E DIN SIZE WEIGHING CONTROLER
4
Activated within 50% of Max. Capacity
5
Activated within 100% of Max. Capacity
6
There is no limit of Zero key operation range.
※ CAUTION : If setting over than 10%, The display weight could be over than Load cell
input signal or Max. Capacity and it may display “CELL-Err” or incorrect weight value.
Tare key Operation Range selection : (-) value is same to (+)
F09
0
Activated within 10% of Max. Capacity
1
Activated within 20% of Max. Capacity
●
2
Activated within 50% of Max. Capacity
3
Activated within 100% of Max. Capacity
“Hold” Mode selection
F10
●
0
Sample Hold : Hold current weight until “Hold Reset”
1
Peak Hold : Measure Max. weight value and hold on display.
2
Average Hold : Hold average value (Refer F-F50)
“STEADY” condition check time setting
F11
03
00
∫
09
During the set time period, estimate weighing part’s “STEADY” condition
and display. If you set small value, indicator will take “STEADY” fast, if you
set value, indicator will take “STEADY” slow.
( 0.5sec per set value)
Display Up-Date speed setting
F12
●
1
60/sec
2
30/sec
3
20/sec
4
15/sec
5
10/sec
6
6/sec
7
3/sec
8
2/sec
9
1/sec
Weight Display selection under “Unpass / OverLoad”condition
F13
0
Not Display Weight (just “UNPASS” or “–OL-“ is displayed)
●
1
Display Weight (with a flash)