G
George ScottJul 27, 2025
What to do if my SFA Dryer pump won't start?
- CCassidy ThorntonJul 27, 2025
If your SFA Dryer pump isn't starting, there could be several reasons: * The unit might not be plugged in; ensure it is properly connected. * A protective bracket may not have been removed; remove it. * The device may not be level; use a bubble level to check the installation. * There may be a power outage; verify the mains voltage. * The float could be blocked; clean the SANICONDENS® tank. * The condensate inlet pipe might be obstructed; clean the SANICONDENS® inlet pipe.