20
Device personality settings
Setting the dimming curve
The setting of the dimming curve will determine the device’s behavior, when changing the light intensity between 0% - 100%.
Linear control provides uniform adjustment throughout the control action, whereas gamma corrected dimming provides finer
control at low light levels, where the eye is more sensitive to change. By default, the P-2 uses gamma corrected dimming.
For uniform response, set all devices to the same dimming curve. To set the desired dimming curve, use the
“Settings→Dimming curve” menu.
Flipping the OLED display
If the device is installed hanging upside down, it might be useful to flip the display so that it is easier to read. To flip the
display, use the “Settings→Flip display” menu, or press the up and down buttons on the control panel at the same time.
Setting the OLED display saver
By default the OLED display dims down after a short period when the control panel is not in use, but it can also be set to turn
off completely. Pressing any key will always turn on the display or restore it to normal brightness. To change the display saver,
use the “Settings→Display saver” menu.
NOTE: To avoid the risk of display deterioration caused by long term use in permanent installations, it is recommended to use
the “Display saver→Display off” setting.
P2 Manual_170x113,3.book Page 20 Wednesday, January 7, 2015 11:47 AM
To Next Page
Loading...