12
Installing the P-2
The P-2 may be installed in any orientation, but if installed
horizontally with a downward beam-angle, water can poten-
tially pool in the fan wells. Under normal operation the mois-
ture will evaporate. However, in locations with high rainfall,
you may wish to fabricate a rain shield above the device, or
modify the position and orientation of the device to minimize
pooling.
For permanent installation on the ground, remove the rubber
feet from the floor stand/base. Fasten securely through the re-
sulting holes with four 6 mm (1/4 in.) corrosion-resistant me-
chanical fasteners suitable for the location.
P2 Manual_170x113,3.book Page 12 Wednesday, January 7, 2015 11:47 AM
To Next Page
Loading...
