8
Avoid personal injury
• Do not look directly at the light source from close range.
• Take precautions to prevent injury due to falls when working at height.
• For permanent installation, ensure that the device is securely fastened to a load-bearing surface with suitable
corrosion-resistant hardware.
• For temporary installation with clamps, ensure that the quarter-turn fasteners are turned fully and secured with a suitable
safety cable. The cable must be approved for a safe working load (SWL) of 10 times the weight of the device, and it must
have a minimum gauge of 2 mm.
P2 Manual_170x113,3.book Page 8 Wednesday, January 7, 2015 11:47 AM
To Next Page
