SGM Studio 12 - 13.17 - Adding a program to a Memory Register; 13.18 - Deleting a program from a Memory Register

page 60
10 - Press the button of the unit to be controlled: .
11 - Set the parameters required on Unit 1.
12 - Press and hold down the Store button, followed by the button of the scene to be stored:
+ .
13 - Press Pause to start the program running again .
13.17 - Adding a program to a Memory Register
1 - Press and hold down the Reg button, then the button of the required Register +
2 - Select Program 1 by pressing PROG + .
3 - Select Scenes, Units and Effects as described in 13.16.
4 - Set running time .
5 - Press and hold down the Store button followed by the Memory Register in which the program
has to be stored: + .
13.18 - Deleting a program from a Memory Register
1 - Press and hold down the Reg button, followed by the button of the required Register +
.
2 - Delete Program 1 by pressing PROG (the LED goes off).
3 - Confirm the operation by pressing and holding down the Store button followed by the button
of the Memory Register the program has to be deleted from + .
1
store
1
1
reg
1
store
rate speed
1
2
3
4
5
6
7
8
9
10
min max
0
1
2
3
4
5
6
7
8
9
10
min max
0
1
1
1
reg
pause
1
store
1