SGS SC50V - Operation and Adjustment Continued; Regulate Output Pressure; Stop Compressor Operation; Vent Compressor After Use

PAGE 13
PAGE 12
OPERATION AND ADJUSTMENT
2. The output pressure of
compressed air can be regulated by
using the regulating valve. turn the
regulation valve knob clockwise to
increase the pressure.
3. When the running compressor
needs to be stopped set the
pressure switch in the off
position.
4. Always vent the compressor
after each use by turning the
regulator knob fully
anticlockwise.
OPERATION AND ADJUSTMENT
5. Once the compressor is
vented, remove any
condensation from inside the
tank by unscrewing the bleed
nipple.
WWW.SGS-ENGINEERING.COM