PAGE 15
PAGE 14
ADJUSTING THE CUT OFF PRESSURE
Then turn the 10mm nut clockwise to increase the pressure and counter-
clockwise to decrease the pressure. Make a half turn on the nut in either
direction, then wait for the tank pressure to equalise. Make further half
turns if required.
ADJUSTING THE CUT OFF PRESSURE
If your compressor cuts out before 10 bar:
Your compressor has been tested during manufacture and the cut off
pressure may be set at 6 bar or 8 bar, rather than 10 bar.
Most applications do not require 10 bar air pressure so we recommend
leaving the cut off pressure at the factory setting unless explicitly required.
If you wish to increase the tank pressure to 10 bar first open the switch
box by unscrewing the single screw:
WWW.SGS-ENGINEERING.COM
To Next Page
Loading...
