15sharkclean.com.nz
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1. Turn o vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings on the dust cup and remove
any debris or blockage.
Checking for Blockages in the Wand:
Standard Wand:
1. Turn o vacuum.
2. Remove the handheld
vacuum and floor nozzle.
3. Check intake openings for
blockages and debris.
4. Clear away debris and
blockages.
MultiFLEX® Wand:
1. Turn o vacuum.
2. Remove the handheld
vacuum and floor nozzle
from the wand.
3. Check the Clog Access
Hose on the Flexology
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out.
4. Clear any debris
and blockages.
Checking for Blockages in the Floor Nozzle:
1. Turn o vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle.
4. Remove the cover and tilt back the neck of the floor
nozzle.
5. Check the opening and remove any debris.
6. Replace the cover by sliding the inserts into the slots,
then pressing down firmly on all sides before turning
the locks clockwise to close, until they click securely
into place.
To Next Page
Loading...
Need help?
General
