In Use: Lights illuminate steadily
Full
Charge
Full
Charge
Nearly
Full
Mid
Charge
Mid
Charge
Low
Charge
Low
Charge
Needs
Charge
Charging: One light flashes
TEMPERATURE ISSUE: FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY
NOTE: The battery must be charged before first use. A complete charge takes approximately 3.5 hours.
NOTE: The indicator light will shut o 5 minutes after reaching full charge.
Charge Indicator
Light
TOP OF BATTERY
CHARGE INDICATOR LIGHTS
If the first and third indicator lights are flashing alternately, the battery
temperature is not optimal. If this happens when charging, leave the battery
plugged in and charging will resume once temperature reaches optimal level.
OPERATING THE VACUUM
OPERATING THE VACUUM
SETTINGS
Press Power button. Select surface setting:
Carpet
For thick pile carpets.
Floor
For hard floors
and rugs.
RUNTIMES
POD, HANDLE AND WAND ARE DETACHABLE
Press the Wand Release button
until it clicks, then pull up on wand
to detach from the floor nozzle.
DETACH THE WAND
Pull the Handle Release trigger to
detach the handle from the wand.
DETACH THE HANDLE
Press LIFT-AWAY button on
handle and lift pod o floor
nozzle.
DETACH THE POD
MODE AND SETTINGS REGULAR BOOST POWER
UPRIGHT & POWERED LIFT-AWAY®
(CARPET)
Up to 30 minutes
Up to 20 minutes
UPRIGHT & POWERED LIFT-AWAY
(FLOOR)
Up to 30 minutes
ABOVE FLOOR & LIFT-AWAY
(WAND OR HANDLE)
Up to 50 minutes
POWER BUTTON SURFACE SUCTION LEVEL
TIP: See next page for all the different
ways you can use your vacuum.
Press icon to boost power:
BOOST
When in Lift-Away®
mode, press BOOST
icon to turn on or o.
The default power setting
on floors and carpets is
extended runtime. For an
additional boost of suction
power, press and hold the
BOOST icon.
IMPORTANT: Your unit will default to Max Power when using in Lift-Away mode.
Max Power shortens runtime.
NOTE: Select Carpet mode for stuck-on dust and debris.
6
5
To Next Page
Loading...
Need help?
General
