EasyManuals Logo
Home>Shark>Vacuum Cleaner>MATRIX 2-in1 RV2400WD Series

Shark MATRIX 2-in1 RV2400WD Series User Manual

Shark MATRIX 2-in1 RV2400WD Series
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
sharkclean.comsharkclean.com
SELF-CLEANING BRUSHROLL
MAINTAINING THE RESERVOIR AND MOPPING PAD
MAINTENANCE
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To clean pads, machine wash warm with light
colors. Use mild detergents and do not use bleach
or fabric softeners. Air-dry, or tumble-dry on low
with no dryer sheets.
Empty the reservoir after each use. Rinse the
reservoir and let it air-dry. DO NOT put the reservoir
in the dishwasher.
To access the brushroll, push up on the tabs on the
brushroll door, then lift o the door.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. Some models come with one side brush. See
sharkaccessories.com for replacement parts.
NOTE: Before storing, make sure the reservoir and pad are completely dry. Store the reservoir and pad in a dry place to
prevent damage.
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSH
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around the brush.
Gently wipe the brush with a dry cloth. To reinstall,
snap the brush over the peg. Spin the brush
manually to make sure it is installed correctly.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust o the sensors
and contacts located on the bottom of the robot and on the dock.
NOTE: Remove and replace the side brush if it is bent or damaged. To remove the brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSH AS NEEDED.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shark MATRIX 2-in1 RV2400WD Series and is the answer not in the manual?

Shark MATRIX 2-in1 RV2400WD Series Specifications

General IconGeneral
BrandShark
ModelMATRIX 2-in1 RV2400WD Series
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals