Suction
Release Collar
area rugs
TO USE:
1 Rotate the cord release to quickly release the
power cord.
2 Secure the power cord in the cord hook.
II .....BrushRollON
I .....BareFloor
0 .....OFF
3 Pressthe 0n/0ff switch (a) to the 'T' position to
vacuum barefloors (straightsuctiononly) orto the
"1t" position to engagethe motorizedfloor brush
(for vacuumingcarpets and rugs),(Fig. 12)
IMPORTANT: Themotorizedbrush indicator light
(b) will illuminate greenwhen motorized floor
brushis on, or red if there isa blockageorjam,
(Fig. 12) Thisfeatureisdesignedto protectyour
Lifetime Beltthat powersyour motorizedfloor
brush.SeeCheckingfor Blockagesonpage 15.
@. 73
4 Gentlypressthe floor nozzledown with your foot
whileyou graspthe handleand tilt it backtowards
you,(Fig. 13)
NOTE: Therotating brushon the motorized
floor brushwill not spin unlessthe nozzle is flat
against the floor and the handle istilted back.
5 Due to the huge suction power of this
vacuum, it may become necessary at
times to adjust the suction release (c) on
the handle. (Fig. 11) If the vacuum seems
difficult to push or pull or if it is lifting
up area rugs, adjust the suction release
by rotating the collar 90 ° counterclockwise
to open the valve. Rotate the collar
clockwise to close the valve when you need
high suction and for vacuuming floors.
6 Emptydust cupafter vacuuming and periodically
during usewhen it appearsfull. (See
"Maintenance" section for instructions.)
7 Whenyou arefinishedvacuuming,turn the
vacuumoff.
NV355 NV356E NV356K NV357 NV355CS NV356KCS IB Eq_u811 4.Jndd 9 11-08-11 12:46PM
To Next Page
Loading...
Need help?
General
