sharkclean.comsharkclean.com
CHARGING THE BATTERY
If your handheld vacuum’s battery is non-removable,
press the Wand Release button to detach the
handheld vacuum, then plug the charger into the
charging port on the handheld vacuum.
Plug the Li-Ion Charger into a wall outlet.
OPTION 1 – NON-REMOVABLE BATTERYLI-ION CHARGER
POWER SETTINGS
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet. The Carpet setting
should also be used when cleaning stuck-on dust and debris.
Slide switch to the top to turn o power.
To begin vacuuming in Standard Mode, slide switch
to the desired setting.
Bare Floor/Small Area Rugs
Use this setting to clean bare floors and small
arearugs.
Carpet
Use this setting to pick up debris below the surface
ofyour carpets.
For an added boost in power, pull the Trigger
on the handheld vacuum. Release it to return to
standard power.
OFF BARE FLOOR SETTING
CARPET SETTING BOOST MODE
If the battery is removable, press and hold the battery
release button, then slide out the battery. Plug the
charger into the charging port on the battery. To re-
install the battery, slide it into the slot in the back of
the handheld vacuum.
OPTION 2 - OUT OF VACUUM
To Next Page
Loading...
Need help?
General
