5
ENGLISH
NOTE
Channel Setting
This function will automatically tune all local channels for you.
The following steps are carried out using the remote control
Initial setting Auto Tuningtunes in and presets receivable TV stations
Automatically tunes in and presets receivable TV stations
1
Press the main POWER button
on the TV.When you install the TV
at first time, it will appears this
picture.
2
AUTO TUNING will start when
selecting “START”, using
CH
and
CH
and pressing
MENU
on
the remote control, or pressing
MENU
on the TV.
All the TV stations in your area
that can be received by the TV set
are automatically preset between
programme position 1 to 99.
The screen shows whatever is on
programme position 1 when full
auto channel preset is finished.
NOTE:Make sure to execute AUTO TUNING until tuning is complete. When EXIT has been
selected during tuning or when the power has been turned off and then turned on again,
the AUTO TUNING screen will be displayed.
After initial setting Auto tuning
Automatically tunes in and presets receivable TV stations
The AUTO TUNING screen will
appear by holding down
MENU
on
the TV for more than 2 seconds.
2
Repeat step 2 above from page 5 (Initial seting)
• To stop AUTO TUNING, press
MENU
on the remote
control.
• When AUTO TUNING is not done, select EXIT
by using
CH
and
CH
on the remote control
or press
MENU
on the TV to return to the TV
screen.
• Make sure to start AUTO TUNING after connecting the antenna, as the AUTO TUNING
screen will be displayed when the power is turned on for the first time.
• Make sure to execute AUTO TUNING until tuning is complete. When EXIT has been
selected during tuning or when the power has been turned off and then turned on again,
the AUTO TUNING screen will be displayed.
• When the Child Lock is set, it is not possible to enter the Tuning mode. This is to make
sure that Child Lock is not over-ridden by re-tuning the set. (To cancel Child Lock please
refer to page 19.)
MENU CH
AUTO TUNING
START EXIT
To Next Page
Loading...
