INDEX
CONTENTS
28
4
If print output is faint, uneven or smeared, follow the steps listed below.
CHECK 1 Has the printer driver been specified to suit
both paper and the print job?
You can select "Draft", "Normal" or "Photo" for the
print quality in the "Advanced" tab of the printer
driver setup screen. When "Photo" is selected, you
can click the "Image Adjustment" button and adjust
the brightness and contrast in the dialog box that
appears. Adjust these settings appropriately for
your print data and try printing again.
Reference: Printer Driver Settings
CHECK 2 Is the paper curled?
If the paper is curled, straighten it up and set it in
the unit again.
CHECK 3 Is the paper too thick or too thin?
Only paper weighing from 56 to 80g/m
2
can be
used in the paper tray. Only paper weighing from 56
to 128g/m
2
can be used in the multi-bypass tray.
CHECK 4 Is it near time to replace the TD cartridge or
drum cartridge?
When it is near time to replace the TD cartridge or
drum cartridge, the TD cartridge replacement
required ( ) indicator or drum cartridge
replacement required ( ) indicator will light
steadily on the unit operation panel. When it is time
to replace either cartridge, the indicator will blink.
Replace the cartridge and try printing again.
Reference: See "TD CARTRIDGE REPLACEMENT",
"DRUM CARTRIDGE REPLACEMENT"
and "ABOUT SUPPLIES AND OPTIONS"
in the Operation Manual.
CHECK 5 Did you set sufficient margins in the paper
settings of your application?
If the margins are set outside of the quality
guaranteed area, smudges or smears may appear
at the upper and lower edges of the paper.
When selecting the paper settings in the
application, set the margins from the top, bottom,
left and right edges of the paper to 4 mm.
Faint, Uneven or Smeared Print Output
To Next Page
Loading...
Need help?
General
