4
34
Using the SPF (AL-2041)
1
Place the originals. (p.27)
Sort mode is normally the default output mode, and thus the SPF and Sort
indicators light up.
2
Press the Two-sided copy/Sort key to select the sort mode.
3
Set the number of copies and other settings, and then press the
start ( ) key.
The copies are delivered to the paper output tray.
• If "Sort auto select" has been set to "2: OFF" in the user programs,
follow the steps below to select sort mode.
• "Sort auto select" can also be used to change the default output mode
(p.66).
• To cancel the Sort copy job, press the clear key.
• To cancel Sort mode, press the Sort/Two-sided copy key repeatedly
until the Sort indicator is off.
(AL-2041)
To Next Page
Loading...
Need help?
General
