Sharp AN-PR1500H - System Setup; Changing the Set Up Menu

19
AN-PR1500H_EN.fm06/3/14
AN-PR1500H
TINSEA127AWZZ
1
Preparation for Use
Changing the set up menu
Notes:
 The setting are stored even if the unit is set to stand-by mode.
 The backup function protects the stored setting for a few hours should there be a
power failure or AC power lead disconnection.
 System set up can be performed during playback mode.
1 2 3
4 5 6
7 8 9
+100
1 Turn on the TV.
2 Set the TV to the correct input, eg. “AV1”, “VIDEO”, etc.
3 Turn on the unit by pressing the
ON/STAND-BY button.
The SHARP startup screen appears.
Note:
Startup screen will be displayed when both S-
Video cable and SCART cable are connected to
the TV. If only the S-Video cable is connected, the
screen may be blank. To set up S-Video mode,
use video out cable or SCART cable.
4 Press the SHIFT and SET UP buttons.
5 Press the or button to select a menu.
 See the list on pages 20 - 25 for set up menu.
6 Press the , , or button to change the setting and press the
ENTER button.
7 After setting is completed, select “EXIT
SET UP”, then press the ENTER button to
return to the main page.