AN-PR1500H_EN.fm06/3/14
TINSEA127AWZZ
28
AN-PR1500H_EN.fm06/3/14
AN-PR1500H
TINSEA127AWZZ
Preparation for Use
Setting the clock (Remote Control only)
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the or button to display the time.
The time display will appear for about 10 seconds.
Note:
The “CLOCK” will appear or time will flash to confirm the time display when the AC
power supply is restored after a power failure or unplugging the unit. If incorrect,
readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1. If the “CLOCK” does not appear in step 3,
step 4 (for selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the or button to select “CLOCK”,
and press the MEMORY/DIMMER button.
4 Press the or button to select 24-hour or 12-hour display and
then press the MEMORY/DIMMER button.
“0:00” The 24-hour display will appear.
(0:00 - 23:59)
“AM 12:00” The 12-hour display will appear.
(AM 12:00 - PM 11:59)
“AM 0:00” The 12-hour display will appear.
(AM 0:00 - PM 11:59)
1 2 3
4 5 6
7 8 9
+100
5 Press the or button to adjust the hour and then press the
MEMORY/DIMMER button.
Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
6 Press the or button to adjust the minutes and then press the
MEMORY/DIMMER button.
Press the or button once to advance the time by 1 minute. Hold it down
to change the time in 5-minute intervals.
1 Clear all the programmed contents. [Refer to “Factory reset, clearing all memory”
on page 62 for details.]
2 Perform “Setting the clock” from step 1.
To Next Page
Loading...
