8
Preparation
• When you attach the stand unit, put the TV on a flat surface.
• Before attaching (or detaching) the stand unit, unplug the AC power cord from the AC power outlet.
CAUTION
• Attach the stand unit in the correct direction.
•
Be sure to follow the instructions. Incorrect installation of the stand unit may result in the TV falling over.
Attaching the stand unit
NOTE
• When installing the stand unit, you need to put your TVon a
surface.flat Before that, put a soft cushion on the surface.
• To detach the stand unit, perform the steps in reverse
order.
• The angle of the stand unit is not adjustable.
• A screwdriver is not supplied with this product.
• During installation, please be careful to avoid getting your
hand trapped between the TV bottom and the floor.
"R"Stand unit
Place the TV on a flat surface with soft cushion on
top of it.The left and right base components are
respectively inserted into the grooves at the bottom
of the TV set, please make sure the raised part of
the base bracket is inserted into the TV set proprely.
Soft cushion
"L"Stand unit
1
2
Insert 4 screws into 4 screw holes on the back of
the TV set and tighten them.
Screws
•
Before performing work, spread cushioning over the surface on which you will be laying the TV.This will prevent it from
being damaged.
To Next Page
Loading...
Need help?
General