13
Preparation
The remote control unit has been pre-paired with the
TV set in factory so you can use the remote control
unit directly. If the remote control fails to operate or
a new remote control unit is used, please follow the
following steps to pair the remote control unit and the
TV.
Remote control pairing
You can also setup the TV through the operation
button at the TV back. (The position of the operation
button, please see page 11)
The operation button
Action Description
Short press Turn on the TV.
Left/Right Set the volume reduction/add.
Up/Down Set the channel up/down.
Long press Display the menu (Pairing ,Power off)
when the TV is switched on.
• If the TV does not display the remote control pairing
information, the "Pairing"
Interface
will be displayed
automatically. Press OK &
(POWER) on the remote
control unit at the same time, the red and blue lights
flash alternately. Once the flashing stop, press OK to
complete the Bluetooth pairing.
• If pairing is not succeed, please try again or contact the
customer service center.
Press the " " button on
the
TV
for a few
seconds, "Pairing "and "Power off " menu will
be displayed.
1
Point the remote control unit towards the
bottom left corner of TV (within 20cm), press
"OK" and "
" at the same time until red and
blue lights stop flashing alternately .
Press "OK" on the remote control unit to
complete the Bluetooth pairing .
3
4
2
Use the operation button on the TV to choose
"Pairing" and then press the TV operation
button.
To Next Page
Loading...
Need help?
General