Sharp AQUOS CRYSTAL 2 - Touchscreen Operations

13
Getting Started
AQUOS CRYSTAL 2
AC Charger
AC Charger is an optional accessory. Be sure to use SHCEJ1 or
ZTDAC1 (Micro USB, 1.0 A) specified by SoftBank Corp.
For information on other peripheral devices, see SoftBank
Website.
The following explains how to charge handset using SHCEJ1.
・See User Guide for corresponding AC Charger.
・Never connect Micro USB plug while handset or AC Charger
is wet.
Insert Micro USB plug of AC Charger into External Device Port
・Insert Micro USB plug in correct orientation; otherwise,
External Device Port may be damaged. Check contours and
orientation of Micro USB plug, then insert it with tabs (○)
facing down.
Extend blades and plug AC Charger into AC outlet
Charging starts and Notification Lamp illuminates.
・Notification Lamp goes out when charge is full.
After charging, remove Micro USB plug from External Device
Port, then unplug AC Charger and retract blades
Charging by PC
Connect handset to a PC with Micro USB Cable (SHDDL1;
optional accessory).
・Make sure that PC is turned on.
・Handset may not charge or charge slowly depending on
connection/PC status.
・Never connect Micro USB plug while handset or Micro USB
Cable is wet.
Insert Micro USB plug of Micro USB Cable into External Device
Port
・Insert Micro USB plug in correct orientation; otherwise,
External Device Port may be damaged. Check contours and
orientation of Micro USB plug, then insert it with tabs (○)
facing down.
Insert USB plug of Micro USB Cable into PC USB port
Charging starts and Notification Lamp illuminates.
・Notification Lamp goes out when charge is full.
After charging, remove Micro USB Cable from handset and PC