EasyManua.ls Logo

Sharp AQUOS CRYSTAL 2 - Operating by Gripping Handset (Grip Magic)

Sharp AQUOS CRYSTAL 2
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
Updating Software Manually
Operate handset where signal reception is good and without
changing location. Also operate with adequate battery charge.
Signal becoming weak or Battery becoming low during an
update may cause an update failure.
・Remove Micro USB Cable (optional accessory) from handset
beforehand; otherwise, Software Update may not complete
properly.
・An update failure may disable handset.
In app sheet, (Settings) About phone
Software update
Software update menu opens.
Software update YES Follow onscreen prompts
Software Update starts.
Software Update Operations
Enabling/Disabling Automatic Updates
In Software update menu, Automatic Update Settings
NOT AUTOMATICALLY UPDATE or AUTOMATICALLY
UPDATE OK
Changing Automatic Update Start Time
In Software update menu, Update Schedule Settings
Select time OK OK
Operating by Gripping Handset
(Grip Magic)
Set actions that occur when handset is picked up or set down.
Grip Magic
Use Grip Magic to perform preset actions when grasping Grip
Sensor Areas or when setting down handset and releasing Grip
Sensor Areas.
The following actions are set by default.
Item Action
Turn screen
on by holding
Display turns on when handset is picked
up (Grip Sensor Areas grasped) with
Screen lock active.
Deterrence
rotate screen
Screen does not change from vertical to
horizontal orientation automatically while
handset is held.
・Change Grip Magic actions as needed. See "Changing Grip
Magic Settings" for details.
Grip Magic Cautions
Grasping Grip Sensor
Grip Sensor responds to touch on both the right and left
of handset. As Grip Sensor does not respond when touched
on only one side, be sure to touch Grip Sensor on both
sides.
Releasing Grip Sensor
Release Grip Sensor on both sides. If one side remains
contacted, Grip Sensor will continue to react.
General Use
Grip Magic may not function properly in the following
cases.
・Operation with gloves worn
・Operation while a metal object is in contact with Grip
Sensor
・Operation when handset is wet
・Attaching or detaching a cover while Grip Magic is
enabled
(Disable Grip Magic, then enable it again.)

Table of Contents

Related product manuals