On-Screen Display Menu
Power Control Menu
Setup Menu
Power control setting allows you to save energy.
Example
EZSetup
1 Press MENU to display the MENU screen, and then
press
....
/~
to select "Setup".
2 Press
JJr..!~
to select a specific adjustment item,
and then press ENTER,
• When you select "EZ Setup", "CH Setup", "Parental
CTRL" or "Reset", you can enter the 4-digit secret
number here. See page 26 for setting a secret number.
3 Press
iJ./~
(or
....
/~)
to select the desired setting,
and then press ENTER.
4 Press MENU to exit.
[English]
MUTE
°
MENU
__
.0
EZ Setup
CH Setup
Antenna Setup-DIGITAL
Input Skip
Parental CTRL
Position
Language
Reset
VOL
CH
SURROUND
j+)
o(d
~,"
Setup
You can run
EZ
Setup again, even after setting up the
preset channels.
Language: Select from among 3 languages (English,
French and Spanish).
TV Location: Select "Home" or "Store" for the location
where you plan to install the
TV.
•
If
you select "Home", AV MODE
is
set to "STANDARD".
•
If
you select "Store", AV MODE
is
set to "DYNAMIC (Fixed)".
In
case no remote control signal
is
received within
30
minutes, AV MODE will change to "DYNAMIC (Fixed)"
automatically.
Air/Cable: Make sure what kind of connection
is
made
with your TV when selecting "Air" or "Cable".
CH Search: Channel auto search makes the TV look for
all
channels viewable
in
the set area.
1m
• See "Initial Setup" on page 15 for setting each item.
•
If
no channel
is
found, confirm the type of connection made
with your TV and try
EZ
Setup again.
•
If
you select "Analog Search Start" and initiate the channel
search, the CH Memory for Cable Digital will be deleted.
No Signal Off [Disable]
No Operation Off [Disable]
No Signal
Off
Example
No Operation Off
I
\,'1
Power Control
I
I
m~$.':
II
EXIT
..
7
RETURN
I
,0
0
1 Press MENU to display the MENU screen, and then
press
....
/~
to select "Power Control".
2 Press
iJ./~
to select a "No Signal Off" or "No
Operation Off", and then press ENTER.
3 Press
....
/~
to select "Enable", and then press
ENTER,
4 Press MENU to exit.
When set to "Enable", the power will automatically shut
down if there
is
no operation for 3 hours.
1m
•
Five
minutes before the power shuts down, the remaining
time displays every minute,
• "Disable"
is
the factory preset value,
When set to"Enable", the power will automatically shut
down if there
is
no signal for 15 minutes.
1m
•
Five
minutes before the power shuts down, the remaining
time displays every minute,
• "Disable"
is
the factory preset value,
• When a TV program finishes, this function may not operate,
@-
24
To Next Page
Loading...
