Sharp AR-203E

AR-203E/5420/M200/M201 DISASSEMBLY AND ASSEMBLY 8 - 8
4) Remove the screw and remove the U-turn guide.
Pressure roller section disassembly
5) Remove the three screws, remove the fusing cover lower on
the right side, and open the heat roller section.
6) Remove the screw and remove the PPD2 sensor.
7) Remove the plate spring on the right and remove the heater
lamp.
8) Remove the spring, and remove the upper separation pawls (3
pcs.).
9) Remove the E-ring and remove the reverse gate.
1)
2)
1)
5)
5)
6)
6)
4)
3)
2)
1)
2)
PPD2 sensor
1)
2)
Heater lamp
3)
1)
2)
2)
1)
3)