SENDING AN IMAGE
19
SCANNING AND TRANSMITTING A TWO-SIDED ORIGINAL
(when using B/W scanner module/DSPF)
If a B/W scanner module/DSPF is installed, a two-sided original can be automatically scanned and transmitted using
the automatic document feeder. Follow the steps below.
1
Make sure the machine is in scanner mode
and then load the document in the
automatic document feeder.
2
Touch the [ORIGINAL] key.
When you touch the
[ORIGINAL] key, check
the original size
displayed in the key.
3
Touch the [2-SIDED BOOKLET] key or the
[2-SIDED TABLET] key as appropriate for
the original you loaded.
If necessary, touch the
[SCAN SIZE] key and
set the original size.
(page 20
)
4
Touch the [OK] key.
You will return to the
initial screen.
A two-sided original icon appears next to the
[ORIGINAL] key.
(Example: The icon that appears when the [2-
SIDED BOOKLET] key is touched.)
5
Continue from step 4 of "BASIC
TRANSMISSION METHOD" (pages 12
to 15).
NOTES
Booklets and tablets
Two-sided originals that are bound at the side are booklets, and two-
sided originals that are bound at the top are tablets.
Two-sided scanning turns off after the document is stored in memory.
Pressing the [CA] key will also cancel two-sided scanning.
To Next Page
Loading...
