Sharp AR-M451U

STORING, EDITING, AND DELETING FROM THE TOUCH PANEL
43
The one-touch keys stored in the group are
highlighted. To add another one-touch key to the
group, touch the key to highlight it.
To delete a one-touch key from the group, touch
the key so that it is no longer highlighted.
5
Make sure the edited information is
correct, and then touch the [EXIT] key.
If you wish to change
another group key,
repeat steps 3 through
5.
The following steps are for deleting a group key.
6
Touch the [DELETE] key.
7
Touch the [YES] key.
If you wish to delete
another group key,
repeat steps 3, 6, and 7.
STORING SENDER INFORMATION
Use this procedure to store the sender information (sender name and e-mail address) that is displayed when the
recipient receives your e-mail. Information for up to 999 different senders can be stored. Select a sender from the
stored senders using the touch panel of the machine when you send an image (page 13
). The selected sender
appears in the sender column of the recipient's e-mail software program.
If you prefer to store sender information from the Web page, refer to page 6
.
1
Press the [CUSTOM SETTINGS] key.
2
Touch the [SENDER CONTROL] key.
3
Touch the [STORE] key.
NOTE
If the assigned three-digit number (see page 38, step
5) is known, you can touch the (Quick) key and
enter the three-digit number using the numeric keys
to add a one-touch key to the group or delete a one-
touch key from the group.
DIRECT ADDRESS / GROUP
SELECT ADDRESS.
A
FREQUENT USE
ABCD
EFGHI
JKLMN
OPQRST UVWXYZ
ABC
GROUP
OK
1/2
* 4
C GROUP ABCD CORPORATION
CORPO.TPS
ADDRESS REVIEW
DIRECT ENTRY
B
DELETE
EXIT
DELETE
EXIT
DELETE THE ADDRESS?
ABCD GROUP
NO YES
NOTE
If you cannot edit or delete a group key
If you attempt to edit or delete a group key in the following situations, a warning message will appear and editing/
deletion will not be possible.
O The one-touch key you wish to change or delete is currently being used for transmission or is used in a currently
stored transmission job.
O The group key is included in a program.
If the key is being used for a current transmission or currently stored transmission, cancel the transmission or wait
until it is completed and then edit or delete the key. If the key is included in a program, delete the key from the
program and then edit or delete the key.
SENDER CONTROL
SETTINGS
T
R
KEY OPERATOR P
NG
STORE
ER CONTROL