STORING, EDITING, AND DELETING FROM THE TOUCH PANEL
47
3
Touch the [SENDING ADDRESS LIST] key.
4
Touch the key of the list you wish to print.
[PROCESSING PRINT
DATA] appears in the
message display and
printing begins.
To cancel printing, touch
the [CANCEL] key.
STORING A PROGRAM
You can store a destination address, erase, dual page scan, 2in1, card shot, and resolution and exposure settings
in a program. This enables you to call up the program and perform the transmission by means of a simplified
operation. (See "USING A PROGRAM" on page 33
.)
1
Press the [CUSTOM SETTINGS] key, touch
the [ADDRESS CONTROL] key, and then
touch the [DIRECT ADDRESS/PROGRAM]
key (refer to steps 1 to 3 on page 38
).
2
Touch the [PROGRAM] key.
3
Touch the [PROGRAM NAME] key.
The "No." that
automatically appears is
the lowest number from
1 to 8 that has not yet
been programmed.
When the [PROGRAM
NAME] key is touched,
the letter-entry screen appears. Enter up to 18
characters for the name.
Refer to Chapter 7 of "Operation manual (for
general information and copier operation)" for the
procedure for entering letters.
4
Touch the [SETTINGS] key.
5
Touch the keys for the settings you wish
to store.
For the detailed procedures for each of the
settings, refer to the explanations of those
features on the following pages.
[RESOLUTION] (page 23
)
[EXPOSURE] (page 23
)
[ADDRESS BOOK] (page 14
)
[SPECIAL MODES]
OERASE (page 25
)
ODUAL PAGE SCAN (page 26
)
O2in1 (page 28
)
OCARD SHOT (page 29
)
NOTES
O The list is printed before other print jobs waiting to be printed.
O If you attempt to print a list when no data exists, a warning message will appear.
NOTE
A timer setting (page 27
) cannot be included in a program.
To Next Page
Loading...
