Sharp AR-M550U - Page 28

TEST SIMULATIONS
28
February 2005
The following pages contain information regarding test simulations. For a more detailed
description for each test simulation, please refer to the AR-M550/620/700 Service Manual.
Copier Simulation Entry Codes
On the copier operation panel, press the following keys:-
PROGRAM CLEAR
Test
Command
Sub
Code
Description
01 Scanner test
1
02 Scanner sensor check
01 DSPF ageing test.
02 DSPF sensor check
2
03 DSPF output check (motor, clutch, solenoid)
02 Finisher sensor check
03 Finisher output check (motor, clutch, solenoid)
10 Finisher adjustment
30 Inserter sensor check
31 Inserter load check
3
32 Adjust Inserter paper width detection level
02 LCC sensor check
4
03 LCC load check
01 LCD/LED test
02 Heater lamp check
03 Scanner lamp check
5
04 Discharge lamp check
01 Paper feed load check
02 Fan motors check
6
03 Transfer unit check
01 Paper feed ageing test setting
06 Interval ageing cycle timer set up
7
08 Warm up time display setting
01 Developer bias setting and output
02 MHV/Grid setting and output
06 THV check and adjust ( transfer).
17 Transfer belt cleaning mode check and adjust
18 Check and adjust the transfer cleaning roller charge
8
19 Check fusing bias voltage
01
Check and adjust the operation and load test.
9
02
Check sensor operation.
01
Toner motor activation.
10
02
Check toner remaining quantity sensor.
**