Sharp AR-M550U - Page 39

JAM CAUSE CODES
39
February 2005
Jam Code Description
JAM Detection
Timer Start Trigger (JAMTST)
JAM Judge Detector
(JAMJD)
PPD_NM2
PPD1 not reached jam
(Tray 4 paper feed)
PFD2 on PPD on
PPD_NLC
PPD1 not reached jam
(LCC paper feed)
MPRD2 on PPD on
PPD_NAD
PPD1 not reached jam
(ADU paper re feed)
PFD2 on PPD on
POD1_N
POD1 not reached jam RRC on POD1 on
POD2_N
POD2 not reached jam POD1 on POD2 on
AINPD_N
Saddle
ADU paper entry
sensor not reached
jam
DGS on (When the paper lead
edge is transported to 30mm
apart from the switchback
operation start position)
AINPD on saddle
AINPD_N
(other)
ADU paper entry
sensor not reached
jam
DGS on (When the paper lead
edge is transported to 30mm
apart from the switchback
operation start position)
AINPD on (Other)
APPD1_N
ADU transport sensor
1 not reached jam
AINPD on APPD1 on
APPD_2N
ADU transport sensor
2 not reached jam
APPD1 on + 90mm APPD2 on
DESK1
Tray 3 paper feed jam
(M1PFD not reached
M1PFC on M1PFD on
DESK2
Tray 4 paper feed jam
(M2PFD not reached)
M2PFC on M2PFD on
M1PFD_N2
M1PFD not reached
jam (Tray 4 feed)
M2PFD on M1PFD on
MPRD2_N2
MPRD2 not reached
jam (Tray2 paper feed)
VPM on (When the paper lead
edge comes to 40mm in front of
the transport roller 4, VPM turns
on)
MPRD2 on
MPRD2_NM
MPRD2 not reached
jam (Manual paper
feed tray paper feed)
VPM on (When the paper lead
edge comes to 40mm in front of
the transport roller 4 ,VPM turns
on)
MPRD2 on
MPRD2_NL
MPRD2 not reached
jam (LCC paper feed)
VPM on (When the paper lead
edge comes to 40mm in front of
the transport roller 4, VPM turns
on)
MPRD2 on
TRAY2
Tray 2 paper feed jam
(MPRD1 not reached)
T2PFC on MPRD1 on
MPRD1_NM
MPRD1 not reached
jam (Manual paper
feed tray paper feed)
MPFD2 on MPRD1 on
MPRD1_NL
MPRD1 not reached
jam (LCC paper feed)
MPFD2 on MPRD1 on
MPFD2 NM
MPFD2 not reached
jam (Manual paper
feed tray paper feed)
MPFD1 on MPFD2 on
MPFD2_NL
MPFD2 not reached
jam (LCC paper feed)
LPPD on MPFD2 on