Sharp AR-M550U - Page 42

JAM CAUSE CODES
42
February 2005
AR-CF2 Inserter (Paper Jam Judgement Conditions)
Jam Code Description JAM Detection Start Trigger JAM Judge Detector
REG_SEN_N
Resist sensor not-
reached jam
Separation start Resist sensor on
REG_SEN_S
Resist sensor
remaining jam
Transport start from take up
position *1
Resist sensor off
TIM_SEN_N
Timing sensor not
reached jam
Resist sensor on Timing sensor on
TIM_SEN_S
Timing sensor
remaining jam
Resist sensor off Timing sensor off
HI_SEN_NI
Paper exit sensor not
reached jam (inserter
paper feed)
Timing sensor on Paper exit sensor on
HI_SEN_NP
Paper exit sensor not
reached jam (Main
unit paper feed)
Main unit paper exit command
receive
Paper exit sensor on
Paper exit sensor
remaining jam (Main
unit paper feed)
After passing by 20mm from the
paper exit sensor on
Paper exit sensor off
HI_SEN_S
Paper exit sensor
remaining jam
(Inserter Paper feed)
Timing sensor off Paper exit sensor off
H_SEN_NIN
Reverse sensor not
reached jam (When
entering the reverse
path)
Timing sensor on Reverse sensor on
H_SEN_NOUT
Reverse sensor not
reached jam (When
exiting from the
reverse path)
Switchback start *2 Reverse sensor on
H_SEN_SIN
Reverse sensor
remaining jam (When
entering the reverse
path)
Timing sensor off Reverse sensor off
H_SEN_SOUT
Reverse sensor
remaining jam (When
exiting from the
reverse path)
After passing 20mm from the
reverse sensor on
Reverse sensor off
*1 The take up position is 30mm downstream from the vertical path transport roller.
*2 The reverse stop position is 20mm downstream from the reverse sensor.