18
Normal department/SICS (Single Item Cash Sale) / SIF (Single Item Finalization)
• If an entry of a department programmed for SICS is made first, the sale will be finalized as soon
as the department key is pressed. If the entry is made after entering a department not
programmed for SICS, the sale will not be finalized until the
;
key is pressed.
• Whenever a sale is made to a department set for SIF, the sale is finalized as soon as the
department key is pressed.
HALO (High Amount Lockout)
• You can set an upper limit amount (HALO) for each department. The limit is effective for the
REG-mode operations and can be overridden in the MGR mode.
• IJ is the same as I x 10
J
.
For example, presetting 14 (100.00) here means that amount entries of up to 100.00 are allowed
in the REG mode. When you preset 17, however, the upper limit amount is 99999.99.
Programming for department 4 as follows: A=0, B=0, C=0, D=0, E=0, F=0, G=1, H=0, I=9 and
J=5.
1.
Press the department 4 key twice.
4 4
• The current parameter setting will be displayed.
2.
Set the parameters as follows:
• You can change the value at the blinker.
Go to the desired position with the following keys:
.
.......
Moves the blinker to the right.
➞
º
.......
Moves the blinker to the left.
➞
• Enter the figure. 0000001095
3.
Press the
≈
key to program this setting.
≈
4.
Press the
;
key to finalize the programming
and generate a programming report.
;
To Next Page
Loading...
Need help?
General
