62
Setting the time range for hourly reports
You can set the time range for an hourly report
.
*A: Time range
To set the time range to 30 minutes (in the 24-hour system), enter 0.
To set the time range to 60 minutes (in the 24-hour system), enter 1.
BC: Starting time (hour = 00 to 23)
To perform this setting, an hourly Z report (# 160) must be done.
RS-232C channel assignment
Your machine is equipped with an RS-232C interface. If you use the on-line communication function, the
channel number of the RS-232C interface must be programmed by using the following procedure.
To realize the on-line communication, consult your dealer.
*P: 1
** Item: Selection: Entry:
A For the ON-LINE communication Disable 0
Enable (enter the channel number) 8
B to D Always enter 0. 0
*P: 2 and 3 (ABCD: Not used. Always enter 0.)
To Next Page
Loading...
