CHAPTER 3. OP X/Z, X1/Z1,X2/Z2
MODE
The following categories of reports can be printed by the ECR.
1) OP X/Z reports (individual clerk reports)
2) X1/Z1 reports (Daily sales total X and Z reports)
3) X2/Z2 reports (Periodic total X and Z reports)
To print reports, use the following key entry sequence
JOB# Range is required
Reading
Resetting
TL
MODE
*
1
OP X/Z X1/Z1 X2/Z2 F-read
*
3 DATA FOR
REPORT NAME X Z X1 Z1 X2 Z2 X1
*
4 JOB# READING NOTE
GENERAL FFFF 00 —
DEPT/GROUP FFF10 —
IND. GROUP FF 12 GROUP No.
GROUP TOTAL FF 13 —
PLU BY RANGE FFFF 20 PLU CODE
*
2
PLU BY DEPT FF 21 DPT CODE
PLU STOCK F 24 PLU CODE
*
2
PLU ZERO SALES FF 27 ALL
PLU PRICE CATEGORY FF 29 PRICE
*
2
TRANSACTION FF 30 —
TL-ID FF31 — ALL CASHIER
COMMISSION SALES FF 32 —
ALL CASHIER FFFF 50 —
IND. CASHIER FFFFFF 51 —
HOURLY (ALL) FF 60
HOURLY (RANGE) F 60
*
2
DAILY NET FFF70
STACKED REP FFFF 90
* 1 X1: Daily X report Z1: Daily Z report
X2: Periodic X report Z2: Periodic Z report
Stop of printing reports:
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MRG" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter don’t return to the original value.
When Z reports, Memory is not reset.
In In-line system, when Master has consolidated the data from
the satellite, ECR can not stop the printing.
* 1 X1: Daily X report
X2: Periodic X report
Z1: Daily Z report
Z2: Periodic Z report
* 2 PLU code range can be specified by entering the start and end
numbers according to the following procedure. When specifying
a single time interval, PLU code, the start number has only to be
entered.
* 3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
Periodic general report; job code 200
* 4 Reading display only
→ KEY → CL
(Display amount) (Display initialize)
KEY DEPT = DEPTn key
CID = ⊗ key
Daily Net = ST key
• An individual report is printed on the receipt and journal when the
TL key is pressed.
• Pressing the decimal point key just after the enery of a job code
clears the corresponding data in the ECR. (Z report)
(When printing those reports for which no Z reports can be taken,
the decimal point key cannot be pressed after the entry of a job
code.)
• When the decimal point key is not pressed after the entry of a job
code, the corresponding data is held in the ECR. (X report)
XXXX
All
Start No.
XXXX
End No.
– 41 –
To Previous Page
Loading...
Need help?
General
