ER-A520/A530 Dealer Knowledge Book
Page 236 of 266 Specifications subject to change without notice: Revision date 10/07
Error Messages
After communications is terminated, one of the following messages is printed.
1. SEND Operation
(1) Normal termination of a “SEND” operation….
I #996 SEND OK I Job No. /Message
(2) Communication Error of a “SEND” operation…
I #996 COM ERROR 01 I Job No./Message/Error Code
(3) Time Out Error of a “SEND” operation…
I #996 TIME OUT I Job No. /Error Message
2. RECEIVE Operation
(1) Normal termination of a “RECEIVE” operation…
I #998 RECEIVE OK I Job No. /Message
(2) Communication Error of a “SEND” operation…
I #998 COM. ERROR 01 I Job No./Message/Error Code
(3) Data Error of a “SEND” operation…
I #998 DATA ERROR 15 I Job No./Message/Error Code
(4) Time Out Error of a “SEND” operation…
I #998 TIME OUT I Job No. /Error Message
3. Error Codes
01 = ID No. Error (ID No. in IDENQ is not correct)
02 = Parity Error
03 = Check Sum Error
04 = Data Size Error
05 = Hardware Error
06 = Power Off Error
07 = Time Out Error
08 = DSR Off Error
11 = Transmit Data Size Error
12 = Block Sequence Error (Irregular Sequence No. has been received)
13 = NAK Code Error (NAK code has been received)
15 = ECR Type Error (Models of the two ECRs are different
Note: All Error Messages are fixed
To Next Page
Loading...
