ER-A520/A530 Dealer Knowledge Book
Page 86 of 266 Specifications subject to change without notice: Revision date 10/07
Section–5: Scanner (Barcode Reader)
The following table shows the related SRV and PGM-Mode Job#s available for the ER-A520 and
ER-A530 ECRs when the Scanner is connected.
Scanner (Barcode Reader)
Mode Job# Description
906-A Stock Counter Availability Function
906-D UPC Look Up at Refund Entry
907-B UPC (EAN) Codes Printing on Receipt and Journal
907-C Enable Negative UPC
909-B Printing of UPC Data when Resetting
911-B C/D Check of UPC (EAN)
921-A Convert UPC-E Codes to UPC-A Codes
971
File Groups 14-22, 23, 24 and 26 -
Optional
Dynamic UPC also known as the UPC Learning Function,
allows you to register a UPC that has not been
programmed in the main PLU/UPC file. The UPC is
added to the Dynamic UPC file memory space, for
temporary storage or for a later upload to the main
PLU/UPC file. This can assist with the register traffic flow
and prevent unwanted and inaccurate items from being
added to the PLU/UPC file. At the end of day and after
verifying the UPCs and making any necessary edits, the
contents of the dynamic UPC file can be downloaded to
the main UPC file using the PGM 2099 job code.
If you do not allocate Dynamic UPC, the UPC Learning
Function is still available. The UPC will add directly to
the main PLU/UPC file. No upload required.
[DEPT#]-Function #106
[AMT]–Function #109
[REPEAT]-Function #110
[INQ]–Function #111
[NO DEL]-Function #112
SRV-Mode
950
[PRCHNG]-Function #113
2690 Channel Assignment
2691 Scanner Settings
1200 UPC (EAN) Programming
PGM-Mode
2616 - P10 ERA530 only Enable to allow Learning Function in REG
mode
To Next Page
Loading...
Need help?
General
